Home
Configure AirCleaner-2 from DashBoard
Configure the AirCleaner-2 using DashBoard.
Network Configuration
To Configure the IP Address from DashBoard
You can set the IP address and network setting from DashBoard.

Configure AirCleaner-2 from DashBoard
Configure the AirCleaner-2 using DashBoard.
- DashBoard Interface
  Use DashBoard to connect to your AirCleaner-2 remotely for setup and operation.
- Network Configuration
  - To Configure the IP Address from DashBoard
    You can set the IP address and network setting from DashBoard.
- Video Reference and Operating Format
- Number of Users
- Total PGM Delay
- PGM Out Audio-Video Offset
- User 2 Delay
- Video Reaction Times
- Audio Reaction Times
- Show Chassis Bypass Control
  The Chassis Bypass Control allows you to show or hide the Chassis Bypass Slider on the AirCleaner Virtual Control Panel.
- AirCleaner Virtual Control Panel Conceal Button Mode
  The conceal buttons on the AirCleaner Virtual Control Panel can operate in either a click and hold or toggle on/off mode.
- End Concealment
- Video Concealment
  Video concealment applies an effect or substitute source to obscure or replace unwanted video.
- Audio Concealment
  Audio concealment applies an effect or substitute source to obscure or replace unwanted audio.
- Video Connections
- Supported Video Formats
- Audio Connections
- Chassis Name
  Each AirCleaner-2 can be given a unique name that appears on the AirCleaner Virtual Control Panel.
- User Profiles
- Software Options
  AirCleaner-2 comes with all the hardware required for the available options. These options can either be licensed at the time you purchase your system, or purchased and installed later on.
- Software Updates
  The software on the AirCleaner-2 can be updated remotely from DashBoard.
- Maintenance
  Refer to the following information for performing maintenance on your AirCleaner-2 or restoring factory defaults.

To Configure the IP Address from DashBoard

You can set the IP address and network setting from DashBoard.

From the DashBoard tree view for the AirCleaner-2, expand the Abekas node and double-click Config Panel.
Click on the System tab.
In the MAIN CHASSIS ETHERNET TCP/IPV4 area, enter the new network setting for your system.

Important: If you change the IP address of the system, you will have to create a new DashBoard connection to the new IP address.
- IP ADDRESS — enter the new IP address for the chassis.
- SUBNET MASK — enter the new subnet mask for the chassis.
- GATEWAY — enter the new default gateway for the system.
Click Apply.