Configure AirCleaner-2 from DashBoard
Configure the AirCleaner-2 using DashBoard.
- DashBoard Interface
  Use DashBoard to connect to your AirCleaner-2 remotely for setup and operation.
- Network Configuration
- Video Reference and Operating Format
- Number of Users
- Total PGM Delay
- PGM Out Audio-Video Offset
  - To Configure the PGM Out Audio-Video Offset from DashBoard
    This adjusts the offset applied to the audio relative to video in tenths of a second to correct synchronization errors.
- User 2 Delay
- Video Reaction Times
- Audio Reaction Times
- Show Chassis Bypass Control
  The Chassis Bypass Control allows you to show or hide the Chassis Bypass Slider on the AirCleaner Virtual Control Panel.
- AirCleaner Virtual Control Panel Conceal Button Mode
  The conceal buttons on the AirCleaner Virtual Control Panel can operate in either a click and hold or toggle on/off mode.
- End Concealment
- Video Concealment
  Video concealment applies an effect or substitute source to obscure or replace unwanted video.
- Audio Concealment
  Audio concealment applies an effect or substitute source to obscure or replace unwanted audio.
- Video Connections
- Supported Video Formats
- Audio Connections
- Chassis Name
  Each AirCleaner-2 can be given a unique name that appears on the AirCleaner Virtual Control Panel.
- User Profiles
- Software Options
  AirCleaner-2 comes with all the hardware required for the available options. These options can either be licensed at the time you purchase your system, or purchased and installed later on.
- Software Updates
  The software on the AirCleaner-2 can be updated remotely from DashBoard.
- Maintenance
  Refer to the following information for performing maintenance on your AirCleaner-2 or restoring factory defaults.

PGM Out Audio-Video Offset

The PGM Out Audio-Video Offset is used to correct any audio-to-video synchronization errors on the incoming audio/video. If an upstream device causes the audio to be 'slipped' in time with respect to the video, this parameter can correct the audio/video synchronization.

The maximum possible audio offset that can be programmed is +/–10 seconds, depending on the current TOTAL PGM DELAY value. The range of the audio offset will decrease if the total program delay is set below 10 seconds.