Configure AirCleaner-2 from DashBoard
Configure the AirCleaner-2 using DashBoard.
- DashBoard Interface
  Use DashBoard to connect to your AirCleaner-2 remotely for setup and operation.
- Network Configuration
- Video Reference and Operating Format
  - To Configure the Video Settings from DashBoard
    You can set the reference type and SDI video output timing in DashBoard.
- Number of Users
- Total PGM Delay
- PGM Out Audio-Video Offset
- User 2 Delay
- Video Reaction Times
- Audio Reaction Times
- Show Chassis Bypass Control
  The Chassis Bypass Control allows you to show or hide the Chassis Bypass Slider on the AirCleaner Virtual Control Panel.
- AirCleaner Virtual Control Panel Conceal Button Mode
  The conceal buttons on the AirCleaner Virtual Control Panel can operate in either a click and hold or toggle on/off mode.
- End Concealment
- Video Concealment
  Video concealment applies an effect or substitute source to obscure or replace unwanted video.
- Audio Concealment
  Audio concealment applies an effect or substitute source to obscure or replace unwanted audio.
- Video Connections
- Supported Video Formats
- Audio Connections
- Chassis Name
  Each AirCleaner-2 can be given a unique name that appears on the AirCleaner Virtual Control Panel.
- User Profiles
- Software Options
  AirCleaner-2 comes with all the hardware required for the available options. These options can either be licensed at the time you purchase your system, or purchased and installed later on.
- Software Updates
  The software on the AirCleaner-2 can be updated remotely from DashBoard.
- Maintenance
  Refer to the following information for performing maintenance on your AirCleaner-2 or restoring factory defaults.

Video Reference and Operating Format

AirCleaner-2 accepts either Bi-Level or Tri-Level analog reference and can be gen-locked to these reference signals only when the frame rate of the reference signal matches the frame rate of the video input and output.

The reference signal will lock both the PGM OUT and TAP OUT together in time with the reference signal. The reference input is non-terminating with loop-though.

Reference can also be set to lock to the PGM IN or AUX IN video signal or set to free run.

The input video signal must be at the same frame-rate as the input reference signal.