To Perform an Audio Only Transition

With the audio override custom controls properly set up, it is possible to perform an audio only transition. This transition does not alter the video signals on the Program or Preset bus, but transitions the audio crosspoints on those buses.

Note:
You must hold the Bank button referred to in step one for the entire procedure. The button must be held to hold the button in Audio Mixer mode.
Tip:
If you run an Assign Audio CC it will show the Audio menu. You can copy this menu to the upper menu area to follow audio overrides as they are applied and adjust the levels if needed.
  1. Press and hold the Audio Bank custom control button to place the bottom panel row into Audio Mixer mode. The source buttons on this bus are now audio crosspoints and represent the audio channels that are on-air and will be taken on-air in the next transition.
  2. Select the audio crosspoint that you want to take on-air on the Preset bus.
  3. Press Auto Trans on the Transition Module for the bottom Crosspoint Group to perform the audio only transition.
    Note:
    Audio Only transitions should only be performed once as they will create audio overrides. In order to properly perform your next transition, you should check the audio crosspoints and run an Audio Reset Pst custom control to return to AFV.