Home
Diagnostics and Maintenance
Switcher status menus and error conditions, installed options, calibration, diagnostics, logs, and replacing hardware.
Installing Frame Boards

Diagnostics and Maintenance
Switcher status menus and error conditions, installed options, calibration, diagnostics, logs, and replacing hardware.
- Switcher Status
  The status menus show information for various components of the frame.
- Front Panel Color Status
  The glow color on the front panel indicates the current operational status of the switcher.
- Switcher Logs
  Switcher logs can be used to identify and diagnose problems with the switcher. Use this information when contacting Ross Video Technical Support.
- Diagnostic Tests
  Diagnostics consist of a number of tests that are used to confirm the functionality of your equipment.
- Error Messages
  The switcher will show an error message on the control panel display when a problem is detected.
- Switcher Reset
  If required, the switcher can be reset to return it to a user-defined default setting (RState), or the factory default state. A reset can be performed for the entire switcher, or individual components, such as keys.
- Frame DIP Switches
  The DIP switches allow you to set default IP address and other diagnostic states.
- Installing Frame Boards
  - To Replace/Install an IO Board
    Replace or add a new Ultra 60 I/O board to your frame.
  - To Replace the Base Board
    Replace the Ultra 60 Base board in your frame.

Installing Frame Boards

Both of the Ultra 60 I/O boards and Ultra 60 Base board can be replaced.

Important: The boards in the Ultra 60 frame are not hot swappable. You must power off the frame before attempting to remove or install a board.

The procedure to replace one of the Ultra 60 I/O boards is slightly different than the Ultra 60 Base board.