Home
Maintenance
There are a number of maintenance and support procedures that are performed to safeguard the proper operation of your switcher, as well as backup your setups.
SDPE Installation

Maintenance
There are a number of maintenance and support procedures that are performed to safeguard the proper operation of your switcher, as well as backup your setups.
- Backup and Restore
- Configuration Files
- Force Panel Upgrade
- Media-Store Permissions
- Dusting Mode
- Factory Default Settings
- Locking Menus
- Power Supply Replacement
- SDPE Installation
  - To Remove an SDPE Blade
    To install the new blade you must power off the frame and remove the old blade or blank plate from the slot.
  - To Install an SDPE Blade
    With the old blade removed, and the power still off and disconnected, you can install the new blade.
- SDPE Reconfiguration for Switcher Type
- SDPE Slot
  The SDPE blades can be moved to different slots in the Ultrix™ chassis or assigned different ME numbers.
- SDPE Reboot
  Manually reboot an SDPE blade.
- SDxE Installation

SDPE Installation

The Software Defined Production Engine (SDPE) provides the hardware resources for a single ME in the Ultrix Acuity switcher. If you are installing a new SDPE blade into the system you must set up the slot and ME for that blade. Refer to SDPE Slot for more information.

To install the SDPE blade you must power off the frame, remove any existing blade from the slot, install the SDPE blade, and power on the frame.

Important: Contact Ross Video Technical Support before moving a blade to a different slot.

Important: The Acuity CPU must be installed in the Ultrix FR5 for the switcher to operate.