Home
Panel Setup
When the TouchDrive panel has been booted in Carbonite mode you can use DashBoard running on the panel to configure network setting and other aspects of the panel setup.
Alarms (TouchDrive)

Panel Setup
When the TouchDrive panel has been booted in Carbonite mode you can use DashBoard running on the panel to configure network setting and other aspects of the panel setup.
- Network Setup
- Date and Time (TouchDrive)
- Touchscreen Configuration
  The touchscreen interface on TouchDrive can be set to show or hide the title bar at the top of the screen as well as change the layout of the onscreen keyboard.
- Alarms (TouchDrive)
- Bus Map

Alarms (TouchDrive)

DashBoard will show an alarm if certain conditions are detected. You can disable these alarms.

To Disable an Alarm

Important: Disabling an alarm is not recommended.

Note: The alarms shown may be different depending on the revision of control panel you have.

From the tree view for the control panel, double-click Configuration > Alarms Enables
Clear the selection for the alarm(s) you want to disable.

Note: Power supplies 3 and 4 (PS 3/4) are only present on revision 03 hardware and are not used at this time.