Technical Specifications

The following table lists technical specifications for the VRzero eSensor Bundle.

Table 1 - Table 3.1

	Property	Details
VRzero Module
	Power Supply	Comes with power supply unit and line cord suitable for the country to which the system is shipped. The power supply unit accepts 100-240VAC at 50/60 Hz, and draws 1.4A current. Power supply unit output is 12VDC (5.0A, 60W maximum).
	Tracking Data Output	Tracking data is transmitted using Kuper protocol over IP. There are 12 data channels, 4 of which carry encoder data. Configure your system to receive data on the following channels: ​Channel 9 — Focus data ​Channel 10 — Zoom data ​Channel 11 — Tilt data ​Channel 12 — Pan data
	Video Reference (genlock/sync)	Video reference (genlock/sync) signal is input through a standard BNC connector. Tri-level and black burst formats are supported. The VRzero module receives video reference signal only; it does not generate the signal.
	Inputs / Outputs	POWER — Power input: 12VDC, 5A SYNC — Video reference (genlock/sync input PAN — Pan axis encoder data input from fluid head. TILT — Tilt axis encoder input from fluid head. LENS — Lens encoder data (zoom, focus) from lens. ETHERNET — Ethernet network connection (RJ-45). Use CAT5e cable (or better).
	Pan and Tilt Encoding	22-bit encoders on pan and tilt axes yield 4,194,304 encoder counts per 360-degree revolution. Scale factor to convert encoder counts to degrees is 0.0000858306884765625. For Ross Video UX VCC, set the pan and tilt encoder scale value to 0.00008583069.
	LED Indicators	POWER LED: ​Solid Red — VRzero module is initializing ​Solid Green — Module is ready. ​Flashing Red — Networking conflict ​Flashing Green — Occurs when module is found by NPort Search Utility’s locate function.
		SYNC LED: ​Solid Green — Video reference (genlock/sync) data is being received.
	Default IP Address	192.168.127.254
	Supported Lenses	The VRzero module has a digital lens interface with auto-detection of Canon and Fujinon lenses. No lens configuration by the user is required. Fully digital lenses with the following types of data ports are supported: ​Fujinon 20-pin virtual port ​Canon 20-pin virtual port
	Compliance Statement	This Class A device complies with Canadian ICES-003 and part 15 of the FCC Rules. Operation is subject to the following conditions: 1) This device may not cause harmful interference and, 2) This device must accept any interference received, including interference that may cause undesired operation.
Encoded Fluid Head		Cartoni eSensor fluid head with encoded pan and tilt axes. The eSensor fluid head mounts to a 100mm bowl.
Cables
	Pan / Tilt Data Cables	Connect between the VRzero module and the eSensor fluid head. Two identical cables, approximately 25” (64cm) long, part number 5120CR-305-xx.
	Lens Data Cable	Connects between the VRzero module and the lens. Two cable assemblies are included: ​For Canon lenses, use Ross Video cable number 900-212-xx. ​For Fujinon lenses, use Ross Video cable number 5100CR-029-xx.
Tripod (not included, but sold separately by Ross Video)		Ross video recommends and sells a Cartoni tripod for use with the eSensor fluid head: Description — Cartoni one-stage aluminum tripod with 100mm bowl base, multi-level tripod spreader, and hooking rubber feet. Order Code — RRB-VR0-ESEN-TRI