Home
Setup
Reference and video I/O setup, networking, and signalling setup.
Video Outputs
Any source in the switcher can be routed to one of the outputs and each output can be assigned to an NDI® stream.
Video Output Setup
You can assign a video source or bus to an output and each output is assigned as an NDI® stream.

Setup
Reference and video I/O setup, networking, and signalling setup.
- Network Setup
  The switcher runs as a service on the PC.
- System Access
  Enable or disable system access and control methods such as FTP.
- Video Mode and Latency
  The switcher can operate in any of the supported video formats (modes). Latency can be used to adjust system performance.
- Video Inputs
  External video sources come into the switcher directly through an NDI® stream, and internal sources are generated internally from the switcher.
- Video Outputs
  Any source in the switcher can be routed to one of the outputs and each output can be assigned to an NDI® stream.
  - Video Output Setup
    You can assign a video source or bus to an output and each output is assigned as an NDI® stream.
    - To Set up a Video Output
      Assign video sources or buses to the output and the output to a framebuffer. Some outputs are fixed to a specific video signal.
  - FlexiClean Clean Feed
    FlexiClean clean feed provides a second program output per ME that is derived from a different point in the video layering than the standard program output. The clean feed can be set to come before any key in the video layering for an ME. This allows you to remove particular keys without affecting the primary program output.
  - ME Follows
    An ME can be linked to another ME so that actions performed on the first are duplicated on the following.
  - On-Air Setting
    Some switcher outputs can be set to be considered on-air or not. This allows you to set which outputs are tallied, how resource allocation is divided, and how the Roll Clip feature works.
- MultiViewer
  The MultiViewer allows you to view multiple video sources from a single output. Video inputs or outputs on the switcher, including Program and Preview, can be assigned to any box on the MultiViewer.
- Personality
  Personality settings allow you to configure how you interact with the control panel and switcher, as well as how the buttons on the control panel appear. All of these settings are stored in the Personality register.
- ViewControl
  The ViewControl interface through DashBoard allows you to coordinate the control over the Carbonite switcher and other devices through custom controls and transitions.
- MultiPanel
  Each frame supports up to 3 independent control connections (Main, Satellite 1, Satellite 2). Each connection can be from a control panel, DashBoard, or a combination of the two. Add devices on the same control connection mirror each other.
- MIDI Controller
  The MIDI controller is used to control the RAVE audio mixer. The controller connects to the switcher through DashBoard.

Video Output Setup

You can assign a video source or bus to an output and each output is assigned as an NDI® stream.

Switcher outputs are assigned to NDI® streams.

Note: If you do note have a valid license, or are using a trial version, Not Licensed is shown on all the outputs of the switcher.