Home
Setup
Reference and video I/O setup, networking, and signalling setup.
MultiPanel
Each frame supports up to 3 independent control connections (Main, Satellite 1, Satellite 2). Each connection can be from a control panel, DashBoard, or a combination of the two. Add devices on the same control connection mirror each other.

Setup
Reference and video I/O setup, networking, and signalling setup.
- Network Setup
  The switcher runs as a service on the PC.
- System Access
  Enable or disable system access and control methods such as FTP.
- Video Mode and Latency
  The switcher can operate in any of the supported video formats (modes). Latency can be used to adjust system performance.
- Video Inputs
  External video sources come into the switcher directly through an NDI® stream, and internal sources are generated internally from the switcher.
- Video Outputs
  Any source in the switcher can be routed to one of the outputs and each output can be assigned to an NDI® stream.
- MultiViewer
  The MultiViewer allows you to view multiple video sources from a single output. Video inputs or outputs on the switcher, including Program and Preview, can be assigned to any box on the MultiViewer.
- Personality
  Personality settings allow you to configure how you interact with the control panel and switcher, as well as how the buttons on the control panel appear. All of these settings are stored in the Personality register.
- ViewControl
  The ViewControl interface through DashBoard allows you to coordinate the control over the Carbonite switcher and other devices through custom controls and transitions.
- MultiPanel
  Each frame supports up to 3 independent control connections (Main, Satellite 1, Satellite 2). Each connection can be from a control panel, DashBoard, or a combination of the two. Add devices on the same control connection mirror each other.
  - To Set Up MultiPanel Permissions
- MIDI Controller
  The MIDI controller is used to control the RAVE audio mixer. The controller connects to the switcher through DashBoard.

MultiPanel

Each frame supports up to 3 independent control connections (Main, Satellite 1, Satellite 2). Each connection can be from a control panel, DashBoard, or a combination of the two. Add devices on the same control connection mirror each other.

The independent control connections are selected by the port you connect to on the frame. Multiple panels and DashBoard connections can connect on the same port, but they will all share the same permissions and mirror each other for control.

Main Panel — 5253 (5258 NAT)
Satellite 1 — 5255 (5259 NAT)
Satellite 2 — 5256 (5260 NAT)
SoftPanel — 5257 (5261 NAT)

Keep the following in mind:

Keep the following in mind when working with MultiPanel:

SoftPanel shares the permissions of the Main Panel.
The assignment of the panel ID is done from the control panel.
Control panel specific personality settings are stored on the frame for the panel ID and are not tied to the control panel.
DashBoard automatically follows the main panel but will ignore permissions set for the main panel.
If you change switcher modes, the MultiPanel permissions may have to be set again.
An undo of a memory recall ignores panel permissions and will undo the last memory recalled from any panel.
Bus maps are specific to each control panel. Creating or updating a bus map for one control panel does not change the bus map on another control panel.
Custom controls ignore control panel permissions and will run events on an ME that the control panel does not have permission for.