Home
Setup
Video input and output setup, networking, and signalling setup.
Network Setup
The switcher runs as a service on the PC.
DashBoard Network Settings

Setup
Video input and output setup, networking, and signalling setup.
- Network Setup
  The switcher runs as a service on the PC.
  - DashBoard Network Settings
    - To Connect DashBoard to the Switcher
      DashBoard connects to the switcher as the main panel, or as a satellite panel or SoftPanel. Connecting as a main or satellite panel is selected by the port used to connect to on the switcher. All DashBoard connections and physical panels that connect on the same port mirror each other.
  - FTP/SFTP Connection
- System Access
  Enable or disable system access and control methods such as FTP.
- Video Mode and Latency
  The switcher can operate in any of the supported video formats (modes). Latency can be used to adjust system performance.
- Video Inputs
  External video sources come into the switcher directly through an NDI® stream, and internal sources are generated internally from the switcher.
- Video Outputs
  Any source in the switcher can be routed to one of the outputs and each output can be assigned to an NDI® stream.
- MultiViewer
  The MultiViewer allows you to view multiple video sources from a single output. Video inputs or outputs on the switcher, including Program and Preview, can be assigned to any box on the MultiViewer.
- Personality
  Personality settings allow you to configure how you interact with the control panel and switcher, as well as how the buttons on the control panel appear. All of these settings are stored in the Personality register.
- ViewControl
  The ViewControl interface through DashBoard allows you to coordinate the control over the Carbonite switcher and other devices through custom controls and transitions.
- MultiPanel
  Each frame supports up to 3 independent control connections (Main, Satellite 1, Satellite 2). Each connection can be from a control panel, DashBoard, or a combination of the two. Add devices on the same control connection mirror each other.
- MIDI Controller
  The MIDI controller is used to control the RAVE audio mixer. The controller connects to the switcher through DashBoard.

DashBoard Network Settings

DashBoard can be connected to Carbonite Code manually. Once connected, DashBoard will remember the connection until you remove it or the IP address changes.