Home
Setup
Reference and video I/O setup, networking, and signalling setup.
Network Setup
The switcher runs as a service on the PC.
FTP/SFTP Connection
To Create an FTP/SFTP Connection
This procedure applies to Microsoft® Windows® 7 and above.

Setup
Reference and video I/O setup, networking, and signalling setup.
- Network Setup
  The switcher runs as a service on the PC.
  - DashBoard Network Settings
  - FTP/SFTP Connection
    - To Create an FTP/SFTP Connection
      This procedure applies to Microsoft® Windows® 7 and above.
- System Access
  Enable or disable system access and control methods such as FTP.
- Video Mode and Latency
  The switcher can operate in any of the supported video formats (modes). Latency can be used to adjust system performance.
- Video Inputs
  External video sources come into the switcher directly through an NDI® stream, and internal sources are generated internally from the switcher.
- Video Outputs
  Any source in the switcher can be routed to one of the outputs and each output can be assigned to an NDI® stream.
- MultiViewer
  The MultiViewer allows you to view multiple video sources from a single output. Video inputs or outputs on the switcher, including Program and Preview, can be assigned to any box on the MultiViewer.
- Personality
  Personality settings allow you to configure how you interact with the control panel and switcher, as well as how the buttons on the control panel appear. All of these settings are stored in the Personality register.
- ViewControl
  The ViewControl interface through DashBoard allows you to coordinate the control over the Carbonite switcher and other devices through custom controls and transitions.
- MultiPanel
  Each frame supports up to 3 independent control connections (Main, Satellite 1, Satellite 2). Each connection can be from a control panel, DashBoard, or a combination of the two. Add devices on the same control connection mirror each other.
- MIDI Controller
  The MIDI controller is used to control the RAVE audio mixer. The controller connects to the switcher through DashBoard.

To Create an FTP/SFTP Connection

This procedure applies to Microsoft® Windows® 7 and above.

Note: FTP must be Enabled (Click Navigation Menu > Configuration > System > Global) to connect to the frame over FTP. If FTP is disabled SFTP will be used. Refer to System Access for more information.

On your computer launch Windows Explorer.
In the address bar, type the following depending on the type of connection you are using.
- FTP — sftp://IP Address of your switcher:8821
- SFTP — ftp://IP Address of your switcher:2222
You are prompted for a username and password.
Type the user name for the application your are creating an FTP/SFTP connection for. Each application has specific requirements. The switcher will set these requirements automatically based on the username.
- xpression – used when creating a connection from a Ross® XPression Motion Graphics System directly to the Media-Store channels on the switcher, as well as any USB drive installed in the switcher.
Enter the password password