To Set the Frame Network Settings

Tip: If you do not know the IP address of the frame, you can set the IP address to the default. Refer to Default Network Settings.
  1. Open a web browser and navigate to the IP address of the switcher frame. You are prompted to enter a user name and password. The defaults are user and password.
  2. Click Other... > Network.

    This page allows you to change the network configuration of the frame network ports, as well as enter the current IP Address of the master panel, and satellite panels.

  3. In the LAN1 section, enter the IP Address and Network Mask for the frame.

    This is the IP address that you will connect to from the control panel(s).

  4. Optional: Set an IP address and network mask for the LAN2 port if required.

    By default, the LAN2 port is turned off. You can use the LAN2 port to connect to an external device or graphics suite.

  5. Optional: Enter the Default Gateway for the frame.
  6. Click Change and Reboot.
    The switcher restarts with the new network settings.