Home
Setup
Network connection, video reference, video input and output setup, switcher personality settings, device control and GPIs, aux panels, color correction, and MultiPanel.
Device Control
Audio Channel Setup
To Assign an Audio Channel to a Video Source

Setup
Network connection, video reference, video input and output setup, switcher personality settings, device control and GPIs, aux panels, color correction, and MultiPanel.
- Network Setup
- Video Reference
- Video Input Setup
- Video Output Setup
- Personality
- GPI Control
- Live Edit Decision Lists
- MultiPanel
- Color Schemes
- Device Control
  - Basic Serial Communications
  - Basic Ethernet Communications
  - Alternate Devices
  - Disable/Enable Device
  - Custom Device Communication
  - Extra Options
  - FlexDevice Drivers
  - Clip Setup
  - Audio Channel Setup
    - To Set Up an Audio Source
      For some audio mixers, each audio source needs to be assigned to an audio channel that is controlled by the switcher. This allows you to select specific audio sources to be controlled when there are more audio sources than input channels on the Audio Mixer.
    - To Assign an Audio Channel to a Video Source
    - To Set Audio Channel Level
      Each audio channel can be set with a custom audio level that is used when the channel is taken on-air. This level can be adjusted manually using the sliders on the Audio Mixer, or by selecting the level on the menu.
    - To Set Up an Audio Group
      Up to three audio channels, or groups, can be grouped together. This allows you to assign multiple audio channels to a single Input BNC. Assigning audio channels will not change the default audio levels that have been set for each of the channels. When the group is taken on-air, each audio channel is taken up to the level set for that particular channel.
    - To Name an Audio Channel
      Each audio channel can have a unique name. This name appears on the mnemonic above the audio fader on the Audio Control module. The color of the mnemonic indicates the status of the audio channel. Orange for an on-air channel, and yellow for an off-air channel. Refer to Topics/Setup/Panel/Audio.html for more information on audio fader mnemonics.
    - To Set an Audio Fade Rate
      Each audio channel can be set to use either the video transition rate, or a unique fade-in and fade-out rate when the audio channel is transitioned on, or off, air.
    - To Set Auto Mute
      You can have the switcher mute an audio channel when the audio level is set to 0. When the audio level is raised again the channel is un-muted. This setting is applied to all audio channels.
- Auxiliary Control Panels
- Panel Modules
- Acuity Rack Panel
- Color Correction
- High Dynamic Range (HDR) and Wide Color Gamut (WCG) Conversion
- SmartConversion

To Assign an Audio Channel to a Video Source

Press HOME > Setup > Installation > Source Configuration > Audio.
Use the Input knob to select the input source that you want to assign an audio channel to.

Tip: The STIL X sources at the bottom of the Input list are to allow OverDrive® to map the Media-Store audio sources to channels for mixer control.
Use the Audio X knob to select the audio channel, or group, that you want to assign to the selected input.

If you have programmed Audio Assign custom controls, the Audio X knobs will display the custom control that the channel has been assigned to.
Press HOME > Confirm.