To Assign a Tally to an Input

  1. Press HOME > Setup > Installation > Source Configuration > Tally.
  2. Press Panel Tallies or ME Tallies to select which tally port you want to set up.
    Note: The TouchDrive panel does not support Panel Tallies.
  3. Use the Panel Tallies or ME Tallies knob to select the tally you want to assign a video source to.
  4. Use the Source knob to select the input source that you want to assign the tally to. Tallies can be assigned to internal outputs, aux buses, and router source.
    Note: If you see multiple Inputs assigned to the same Ext. Source, the tally may not function properly. The switcher identifies the tally state based on the Input, but the TSL tally information is based on the Ext. Source (Ultrix™ Source). This can lead to an Ultrix™ source being reported as both on-air and off-air at the same time.
  5. Use the Mode knob to select when you want to tally the selected source.
    • On Air — when the source is on-air. The source is on-air when it is included in the program output of an ME that is tallied.
    • Preview — when the source is on preview.
    • BnkXAuxY — when the source is active on the selected aux bus.
    • Any Aux Bus — when the source is active on any aux bus.
    • Preset — when the source is active on the preset of any ME.
    • ME X PGM Y — when the source is active on the selected program output of the selected ME.
    • ME X PST Y — when the source is active on the selected preset output of the selected ME.
  6. Press HOME > Confirm.