To Set Up a CCU Joystick Control

  1. Press HOME > Setup > Installation > Aux Bus > Remote Panels > Remote GPI Assignment.
  2. Use the Remote knob to select the auxiliary control panel GPI input that you want to assign an aux bus to.
  3. Use the Aux Bus knob to select aux bus that you want to assign to the selected GPI.
  4. Use the Source knob to select the video source that you want to be selected on the aux bus when the GPI is triggered.
  5. Press Remote GPI Type.
  6. Use the Remote knob to select the auxiliary control panel GPI input that you want to set the trigger type for.
  7. Use the Type knob to select the type of trigger signal that you want to use.
    • Low-Override — set the trigger as a temporary override when the circuit is closed (high to low signal). When the circuit opens again (low to high signal), the aux bus output returns to the selected video signal.
    • Low-Toggle — set the trigger as a toggle when the circuit closes (high to low signal). Every time the circuit closes, the override state will toggle.
    • High-Toggle — set the trigger as a toggle when the circuit opens (low to high signal). Every time the circuit opens, the override state will toggle.
    • Latch — set the trigger to latch when the circuit opens or closes. Once latched, the trigger cannot be released except by selecting a different source on the Auxiliary Panel itself.
    • Off — disable GPI trigger.
  8. Press HOME > Confirm.