Home
Setup
Setup of channel allocation, video format, video codecs, timecode, audio and video routing, remote communications and more.
Remote Control Support
Use the information in this section to assist you in setting up an external device to control your server.
Remote Communications (RS-422)
Direct serial control of two channel transports is available through the RJ45 ports on the breakout cable connected to the server. Ethernet communications can also be used to control all channel transport instead of the direct serial connection.

Setup
Setup of channel allocation, video format, video codecs, timecode, audio and video routing, remote communications and more.
- Server Configuration
- Remote Control Support
  Use the information in this section to assist you in setting up an external device to control your server.
  - Remote Communications (RS-422)
    Direct serial control of two channel transports is available through the RJ45 ports on the breakout cable connected to the server. Ethernet communications can also be used to control all channel transport instead of the direct serial connection.
    - To Configure a Room for the BVW-75 Protocol
      Set up a Room to use the BVW-75 protocol to control server channels.
    - To Configure a Room for the Odetics Protocol
      Set up a Room to use the Odetics protocol to control server channels.
    - To Configure a Room for the VDCP Protocol
      Set up a Room to use the VDCP (Louth) protocol to control server channels.
    - To Configure a Room for the AMP Protocol
      Set up a Room to use the AMP protocol to control server channels.
  - DashBoard
  - Clip ID Support
  - Sony® MVS Series Switcher
- Maintenance
  Refer to the following information for performing maintenance on your server, muting an alarm, restoring factory defaults, or upgrading the software.
- AsRun Log Creator
  The server keeps a log of stills and clips that have been played in their entirety on all channel of the server. This information can then be filtered and output into either a CSV file or a PDF report.
- Troubleshooting

Remote Communications (RS-422)

Direct serial control of two channel transports is available through the RJ45 ports on the breakout cable connected to the server. Ethernet communications can also be used to control all channel transport instead of the direct serial connection.

Note: The BVW-75 and Odetics protocols are not supported over ethernet at this time.

The procedure for setting up a room for external control depends on the protocol you want to use.