Home
Setup
Reference and video I/O setup, networking, and signalling setup.
ViewControl
The ViewControl interface through DashBoard allows you to coordinate the control over the Carbonite switcher and other devices through custom controls and transitions.
ViewControl Overview
Transition Buttons

Setup
Reference and video I/O setup, networking, and signalling setup.
- Network Setup
  The switcher runs as a service on the PC.
- System Access
  Enable or disable system access and control methods such as FTP.
- Video Mode and Latency
  The switcher can operate in any of the supported video formats (modes). Latency can be used to adjust system performance.
- Video Inputs
  External video sources come into the switcher directly through an NDI® stream, and internal sources are generated internally from the switcher.
- Video Outputs
  Any source in the switcher can be routed to one of the outputs and each output can be assigned to an NDI® stream.
- MultiViewer
  The MultiViewer allows you to view multiple video sources from a single output. Video inputs or outputs on the switcher, including Program and Preview, can be assigned to any box on the MultiViewer.
- Personality
  Personality settings allow you to configure how you interact with the control panel and switcher, as well as how the buttons on the control panel appear. All of these settings are stored in the Personality register.
- ViewControl
  The ViewControl interface through DashBoard allows you to coordinate the control over the Carbonite switcher and other devices through custom controls and transitions.
- MultiPanel
  Each frame supports up to 3 independent control connections (Main, Satellite 1, Satellite 2). Each connection can be from a control panel, DashBoard, or a combination of the two. Add devices on the same control connection mirror each other.
- MIDI Controller
  The MIDI controller is used to control the RAVE audio mixer. The controller connects to the switcher through DashBoard.

Transition Buttons

The transition buttons allow you to select what is included in the next transition, what type of transition is to be performed, and perform the transition. These buttons function similarly to the buttons in the Transition Area on the control panel.

To Perform a Transition

Click the button and select the ME or MiniME™ that you want to perform the transition on.
Click the BKGD and Key button over the Preview box to select what to include in the next transition.
Click Auto to perform the transition, or Cut to perform a cut transition.