Editor Extra Options

Option	Value
Bus Mapping	Select either the original GVG4000 bus mapping (Normal), or the current direct one-to-one bus map of the switcher (Simple).
CustCtrl ME	Select whether memory recalls on a particular ME perform a custom control rather than recalling the memory. The specific custom control that is run is based on the memory that is being recalled. Memories 1-19 correspond to Bank 1, Custom Controls 1-20; memories 20-39 correspond to Bank 2, Custom Controls 1-20; and so on. Any — memory recalls for any ME run a custom control rather than recall a memory. Pgm-Pst — memory recalls for the main program ME run a custom control rather than recall a memory. ME`X` — memory recalls on ME `X` run a custom control rather than recall a memory.
Editor Type	Select the type of editor you are connecting to the selected communications port.
Pattern	Select wipe patterns using wipe pattern numbers (Pattern #) or wipe button numbers (Wipe Button).
Use Break	Select whether the switcher must receive a break command and an address before going into active mode (Yes), or the switcher goes into active mode without receiving a break command (No).

Bus Mapping

Select either the original GVG4000 bus mapping (Normal), or the current direct one-to-one bus map of the switcher (Simple).

CustCtrl ME

Select whether memory recalls on a particular ME perform a custom control rather than recalling the memory. The specific custom control that is run is based on the memory that is being recalled. Memories 1-19 correspond to Bank 1, Custom Controls 1-20; memories 20-39 correspond to Bank 2, Custom Controls 1-20; and so on.

Any — memory recalls for any ME run a custom control rather than recall a memory.
Pgm-Pst — memory recalls for the main program ME run a custom control rather than recall a memory.
MEX — memory recalls on ME X run a custom control rather than recall a memory.

Editor Type

Select the type of editor you are connecting to the selected communications port.

Pattern

Select wipe patterns using wipe pattern numbers (Pattern #) or wipe button numbers (Wipe Button).

Use Break

Select whether the switcher must receive a break command and an address before going into active mode (Yes), or the switcher goes into active mode without receiving a break command (No).