To Recall a Switcher Setup

Note: If the installation register you are recalling has an input processor board (MultiProcessor Input or 12G MultiProcessor Input) set to a different mode (Mode 1 or Mode 0) than it is currently operating in, it will take an extended amount of time for the input processor board to be fully functional. For example, the Input MultiViewer will take longer to display.
Note: If you are updating an older setup file, you must perform a Recall All followed by a Store All. This updates the setup files to the latest format. You can then make changes and store to individual registers if needed.
  1. Press HOME > Disk > Dest/Source.
  2. Use the Disk Type knob to select whether you want to use the hard drive of the switcher (Hard Drive), or a USB drive (USB).
    Note: You cannot store or recall files from the USB on the Acuity Rack Panel server. You must store or recall the files from the Local Disk and access it over the network. Point your file explorer to the localdisk folder on the server (\\##.##.##.##\localdisk). The user name is nobody and there is no password.
  3. Use the Set Names knob to select the setup on the drive you want to use.
  4. Press Recall.
  5. Select the individual registers, or all of them (All), to be recalled from the setup. As you press the buttons, the switcher recalls those registers from the setup.
    Note: If you are including MediaStore as part of the recall, you must restart the switcher (Press HOME > More > System Shutdown > Restart) after the recall for the changes to the Media​-Store to be applied.