To Set Up a MediaWipe

A MediaWipe requires that you select the animation you want to use and then set up how you want to transition performed under the animation. This information is stored with the media item when you press save.

  1. Click Navigation Menu > Live Assist > MEs and select the ME that you want to perform the transition on.
  2. Click Trans > Media, or press MEDIA in the Transition area on the control panel.


  3. In the Media Status area, click a Media X button to select the channel you want to assign an animation to.
  4. In the Media Selection area, click the button for the animation you want to assign to the Media​-Store channel.
  5. In the Trans Layer area, select where the MediaWipe will occur.
    • AutoMediaWipe occurs over highest number key in the transition.
    • BkgdMediaWipe occurs over the background, but under all keys.
    • Key1MediaWipe occurs over the background and key 1, but under remaining keys.
    • Key2MediaWipe occurs over the background and key 1 and 2, but under remaining keys.
    • Key3MediaWipe occurs over the background and key 1-3, but under key 4.
    • Key4MediaWipe occurs over the background and key 1-4, but under key 5.
    • Key5MediaWipe occurs over the background and key 1-5, but under key 6.
    • Key6MediaWipe occurs over the background and all keys.
    Important: If a key is above the MediaWipe layer and included in the MediaWipe transition, it will cut off-air with the transition. This is normally covered by the animation when the layer is above the key.
  6. Click Edit Media Trans.


  7. In the Media Over area, select the type of transition you want to use under the MediaWipe. This also allows you to set up the transition parameters for wipes and DVE transitions.
  8. Click Trans Time and use the Fader slider or fader in the Transition area on the control panel to set the start and end of the transition under the MediaWipe.
    • (Cut only) Use the Cut Frame slider to select the point for the cut, or move the fader to the point in the animation where you want the cut to happen and click Cut at Fader Position.
    • Use the Start Trans At slider to select the point where the transition starts, or move the fader to the point in the animation where you want the transition to start and click Start Trans at Fader Position.
    • Use the Trans Rate slider to select the duration of the dissolve, or move the fader to the point where you want the transition to end and click End Trans at Fader Position.
    Tip: If you select a negative start point for the transition, the transition will start first and then the animation will play after the start point duration has passed.
  9. Click Thumbnail and use the Thumbnail Frame slider to select a point in the animation that you want to use as a thumbnail for the MediaWipe. You can also use the fader to select the position and click Generate Thumbnail at Fader Position.


  10. Click Save to save the new setting to the selected media item.
  11. Click Exit Edit Media Trans.