To Load a Set

Load the switcher set to restore a copy of the previous configuration of the switcher.

Note: If you are updating an older setup file, you must perform a Recall All followed by a Store All. This updates the setup files the latest format. You can then make changes and store to individual registers if needed.
  1. Insert a USB drive into a USB Port on the frame. You must wait 5 seconds for the switcher to recognise the USB drive.
    Important: Only ONE USB should be installed in the frame at any one time. USB drives are numbered according to the order they are discovered by the operating system and not the USB port they are installed in.
    Tip: If you do not have a USB drive, you can recall the set from temporary storage. This set will be lost when the switcher restarts. Importing a set from an external computer will be stored in the temporary storage.
    Tip: For best performance it is recommended that the USB drive be formatted using the exFAT file system.
  2. Click Navigation Menu > Configuration > System > Load Sets.
    Tip: Click Refresh Sets to update the list of available sets on the USB.


    Tip: You can import a switcher set from your local computer in the Import Set to Available Sets area. Click Import As and navigate to the folder where the set is stored and click Open. It may take several minutes for the set to upload to the switcher.
    Tip: You can delete a set you no longer want by selecting the set and clicking Delete Set.
  3. Select where you want to load the switcher set from.
    • Internal — load the set from the internal drive of the frame.
    • USB 1 — load the set from the USB drive.
  4. Click an Available Sets button to select the set you want to load the switcher register from.
  5. Click a Load Set from USB button to load that register. Only those registers that are present in the set are shown.
    • All — recall all registers from the set. RPM Licensing is not included.
    • Memories — recall only the memory registers from the set.
    • Customs — recall only the custom control registers from the set.
    • Sequences — recall only the Sequencer registers from the set.
    • UltraScenes — recall only the UltraScene registers from the set.
    • Installation — recall only the installation registers from the set.
    • Personality — recall only the personality registers from the set.
    • RPM Licensing — recall only the software licenses requested from Ross Platform Manager.
      Note: Recalling an RPM Licensing set that requests or releases RPM licenses may require the restart of the switcher to apply the licenses.
  6. Click Yes.