To Store a Set

Switcher Sets are stored to the local hard drive. A link to the folder is located under the Carbonite Code entry on the Start menu.

Note:
If you are updating an older setup file, you must perform a Recall All followed by a Store All. This updates the setup files the latest format. You can then make changes and store to individual registers if needed.
Tip:
The switcher provides 10 empty sets by default. Additional sets can be created if you rename the sets from Windows®.
  1. Click Navigation Menu > Configuration > System > Save Sets.
    Tip:
    Click Refresh Sets to update the list of available sets.


  2. Click a Select Set button for the set you want to store the switcher registers to.
  3. Click a Save button to save that register to the selected set. If the button is shown in brown, that register already exists in the set and will be overwritten.
    • All — store all registers to the set.
    • Memories — store only the memory registers to the set.
    • Customs — store only the custom control registers to the set.
    • Sequences — store only the Sequencer registers to the set.
    • UltraScenes — store only the UltraScene registers to the set.
    • Installation — store only the installation registers to the set.
    • Personality — store only the personality registers to the set.
    • MotionText — store only the MotionText registers to the set.
  4. Click Yes.

The registers are stored to the set on the hard drive.

Tip:
You can export the switcher set to your local computer in the Export Set From Frame area. Click Export As... and navigate to the folder where you want to store the file and enter a name. Click Save and then Export.