To Perform a Transition on TouchDrive (No Memory Area)

All transitions, with the exception of cuts on the background or key bus, have the same basic setup. The control panel offers physical buttons and mnemonics to setup and perform the transition.

  1. Select the preset or key sources that you want to transition to on the buses.
    Tip: You can perform a quick, or hot, cut on the background bus by simply selecting a different source.
  2. In the Transition area, select the elements you want to include with the transition. If you are including multiple elements, press and hold the first button and press the other buttons to include them in the same transition.
    Note: A key should be included in the transition if it is going on-air or off-air. The transition changes the on-air state of the keyer. If a key is on-air, a red indicator is visible on the display just above the key and the CUTbutton for that key is red in the Keyer area.


  3. In the Transition area, select the type of auto transition you want to perform. Refer to the manual that came with your switcher for information on setting up these transitions.
    • DISS — perform a dissolve transition
    • WIPE — perform a wipe transition
    • DVE — perform a DVE transition
    • MEDIA WIPE — perform a MediaWipe transition
    Note: The TRANS X buttons are configurable and can be assigned different functions.
  4. The display in the Transition area shows the current setting for the transition type. Tap one of theses settings to show additional options.
    Tip: Live Assist follows the transition type selection and shows the settings for that transition type.


    • Left — the left button shows the current pattern for the wipe or DVE transition. Tap the button and swipe left or right on the display to select a different pattern. For a MediaWipe the button shows the name of the media item being used for the transition.
    • Center — the center button shows the current direction for the wipe, DVE, or MediaWipe transition. Tap the button and select a different direction for the transition to be performed in.
    • Right — the right button shows the current position of the pattern for the wipe transition or the settings for the MediaWipe transition. Tap the button to have the 3-knob display show the position setting of the pattern and use the positioner to move the pattern around.
  5. Set the rate for the transition you want to perform.
    • Background
      1. On the Transition area tap Rate and use the 3-knob menu to enter the new rate.


    • Key Only
      Note: The KEY RATE is only used for key only transitions. Keys included in with the background are transitioned a the ME Rate.
      1. On the Keyer area tap the key you want to set the rate for.


      2. Tap Rate and use the 3-knob menu to enter the new rate.
  6. Perform the transition.
    • Auto Transition — press AUTO. The transition is performed at the set transition rate.
    • Cut — press CUT.
    • Fader — move the fader from one limit to the other. The rate at which you push the fader determines the speed of the transition.
  7. If a pre-delay has been set, and the ROLL CLIP button is active, the switcher will apply the pre-delay interval before performing the transition.