Home
Configure AirCleaner-2 from DashBoard
Configure the AirCleaner-2 using DashBoard.
DashBoard Interface
Use DashBoard to connect to your AirCleaner-2 remotely for setup and operation.
To Connect to AirCleaner-2 from DashBoard

Configure AirCleaner-2 from DashBoard
Configure the AirCleaner-2 using DashBoard.
- DashBoard Interface
  Use DashBoard to connect to your AirCleaner-2 remotely for setup and operation.
- Network Configuration
- Video Reference and Operating Format
- Number of Users
- Total PGM Delay
- PGM Out Audio-Video Offset
- User 2 Delay
- Video Reaction Times
- Audio Reaction Times
- Show Chassis Bypass Control
  The Chassis Bypass Control allows you to show or hide the Chassis Bypass Slider on the AirCleaner Virtual Control Panel.
- AirCleaner Virtual Control Panel Conceal Button Mode
  The conceal buttons on the AirCleaner Virtual Control Panel can operate in either a click and hold or toggle on/off mode.
- End Concealment
- Video Concealment
  Video concealment applies an effect or substitute source to obscure or replace unwanted video.
- Audio Concealment
  Audio concealment applies an effect or substitute source to obscure or replace unwanted audio.
- Video Connections
- Supported Video Formats
- Audio Connections
- Chassis Name
  Each AirCleaner-2 can be given a unique name that appears on the AirCleaner Virtual Control Panel.
- User Profiles
- Software Options
  AirCleaner-2 comes with all the hardware required for the available options. These options can either be licensed at the time you purchase your system, or purchased and installed later on.
- Software Updates
  The software on the AirCleaner-2 can be updated remotely from DashBoard.
- Maintenance
  Refer to the following information for performing maintenance on your AirCleaner-2 or restoring factory defaults.

To Connect to AirCleaner-2 from DashBoard

Click File > New > TCP/IP DashBoard Connect or openGear Device.
In the IP Address field, enter the IP address of the AirCleaner-2 chassis. The default IP address is 192.168.0.1.

Tip: If you do not know the IP address of the AirCleaner-2 chassis, you can use the Chassis Menu to navigate to IP Config Menu (Turn the SELECT knob to IP Config Menu and press the SET knob). The menu shows the current IP address and allows you to default it.
In the Display Name field, enter the name you want to use to identify the AirCleaner-2 chassis in DashBoard. This should be a unique name for the AirCleaner-2 you are setting up.
Select JSON.
In the Port field, enter 5254.
Click Finish.

The AirCleaner-2 you are connecting to appears in the Tree View.