Gallery

This setup information applies to the Gallery Sienna.

Note: The Sienna does not support using a semicolon ";" in a clip name.

Cable Connections

The device connects to the switcher over a standard ethernet connection.

Switcher Setup

The switcher must be set up to communicate with the video server using either serial or ethernet protocols, as well as associate the video inputs that are coming into the switcher from the video server with the channel on the device that they are coming from.

Note: If you are using multiple video channels, each channel should be assigned to a separate port, or a port expander should be used.

To Set Up Communications

  1. Press HOME > Setup > Installation > Com Setup
  2. Press Type and use the Com Port knob to select the net port that you want to set up for the device.
  3. Use the Device knob to select VTR (CLIP).
  4. Press Select Device and use the Device knob to select VDCP.
  5. Use the Device Preroll knob to select 0.
  6. Press Com Type and use the Type knob to select Network TCP.
  7. Press Com Settings and use the Client/Server knob to select Client and enter the IP Settings.
    IP Setting Value
    Remote IP Address (IP of device)
    Remote Port 10000
    Local IP Address 0.0.0.0
    Local Port 0
  8. Press Extra Options and use the Option and Value knobs to set the device parameters.
    Option Value
    TargetMachine Generic
    Note: The remaining extra options are set automatically when the target machine in selected.
  9. Press More > VDCP.
  10. Use the Main/Associate knob to select where the device gets the clip list.
    Note: This feature requires multiple devices with the same clips loaded on them. Only the clip list from the main is loaded. Associate devices are assumed to have the same clips and the clip list from the main device is used. This saves loading the same clip list from a different server when switching between the devices.
    • Main — the device with the main clip list.
    • Associate — the main device clip list is used instead.
  11. Use the Main Port knob to select the device and clip list to use instead of loading the list from the current device. Only those devices that have been set to Main are listed.
  12. Press HOME > Confirm.

To Set Up a Video Input

  1. Press HOME > Setup > Installation > Source Configuration > Input Type.
  2. Use the Input knob to select the input source that you want to configure.
  3. In the Input Type area, select VTR.
  4. Press More > VTR/VDCP/AMP Xpts and use the Controller knob to select the device that the video signal is coming from.
  5. Press Video Server Setup and use the Channel and SubAddress knobs to select the video output channel you are controlling on the device (channel) and 0 (sub-address).
    • VDCP — leave the Channel selection at 1. The channel transport selection is made by the ethernet port that you are controlling.
    • AMP — use the Channel knob to select the number 0-11 that corresponds to the channel transport (A-L) that the video source is from.
    Tip: Press More > Channel Name to give the video server channel a new name.
  6. Press HOME > Confirm.

OverDrive® Application Notes

  • The clip length is always displayed as 1:00, regardless of the clip length, when using a MOS work-flow.
  • The timer in the window always stays at zero.
  • If you are using the Sienna in an ENPS environment, the system does not support clip names that contain spaces.