Sierra Video

This setup information applies to the Sierra Video Yosemite.

Cable Connections

The device connects to the switcher over an RS-422 serial connection to a DB9 port on the switcher and a DB9 port on the device.

Table 1. Switcher to Yosemite Cable Connections
Acuity (Remote Port) Yosemite (RS232RS422 Port)
2 (Rx-) 2 (Tx-)
3 (Tx+) 3 (Rx+)
7 (Rx+) 7 (Tx+)
8 (Tx-) 8 (Rx-)

Switcher Setup

The switcher must be set up to communicate with the router, as well as associate the video inputs that are coming into the switcher from the router with the specific router they are coming from.

To Set Up Communications

  1. Press HOME > Setup > Installation > Com Setup
  2. Press Type and use the Com Port knob to select the remote port that you want to set up for the device.
  3. Use the Device knob to select Router.
  4. Press Select Device and use the Device knob to select Yosemite.
  5. Press Com Type and use the Type knob to select RS-422.
  6. Press Com Settings and use the Baud and Parity knobs to select 38400 (Baud) and NONE (Parity).
  7. Press Extra Options and use the Option and Value knobs to set the device parameters.
    Option Value
    Src Xpts 128 (default)
    Dest Xpts 128 (default)
  8. Press HOME > Confirm.

To Set Up a Video Input

  1. Press HOME > Setup > Installation > Source Configuration > Input Type.
  2. Use the Input knob to select the input source that is coming from the router.
  3. In the Input Type area, select Router.
  4. Press More.
  5. Press Router Setup and use the Router knob to select the router that the video source is coming from.
  6. Use the BNC DST knob to select the destination, or output, on the router that is feeding the selected input BNC.
  7. Press Router Options and use the Level knob to select the level, or breakaway, that is switched on the router when a new input is selected.
  8. Use the Show Mnemonics knob to select whether the router source name is shown on the mnemonic for the selected input (Yes) or if the switcher source name is shown (No).
  9. Press HOME > Confirm.

Router Mnemonic Names

If your router/protocol does not support passing mnemonic names to the switcher, you can manually add those names. Refer to Router Mnemonic Names for more information.