To Load a Set

Switcher Sets can only be loaded from a USB drive. The USB drive must be present before you try to load the settings.

  1. Insert your USB drive into the USB Port on the switcher. You must wait 5 seconds for the switcher to recognise the USB drive.
  2. Click Navigation Menu > Configuration > System > Load Sets.
  3. Click the Select Set button for the set you want to load from.
  4. Click the Load button for the registers you want to recall from the selected set. The button will appear gray if that register is not present in the set.
    • All — recall all registers from the set.
    • Memories — recall only the memory registers from the set.
    • Installation — recall only the installation registers from the set.
  5. Click Ok.