Home
Setup
Setup of channel allocation, video format, video codecs, timecode, audio and video routing, remote communications and more.
Server Configuration
Channel Setup
To Configure the Hardware Channels
The number of hardware channels on your server depends on the configuration you purchased.

Setup
Setup of channel allocation, video format, video codecs, timecode, audio and video routing, remote communications and more.
- Server Configuration
  - Channel Setup
    - To Configure the Hardware Channels
      The number of hardware channels on your server depends on the configuration you purchased.
  - Video Formats
    Select the video format that the server is operating in, and the source of the reference signal.
  - Video Router Setup
    You can connect the server to an external router and control the sources feeding the server.
  - Audio Setup
    You can select the number of audio tracks to record, which sources audio will use, and how audio is muted.
  - Audio Router Setup
    There are two integrated audio routers built into the server. An input router that sends audio from an audio input to any channel transport, and an output router that sends the audio from a channel transport to any audio output. The number of audio inputs and outputs depends on the options you have installed in your server.
  - Timecode Setup
    The selected timecode information that is recorded with the video can be overlaid on the output video stream of the server. This can be time of day linear timecode (LTC) coming into the server, or the embedded ancillary timecode (ATC) in the video stream being recorded.
  - Channel Label Setup
    You can assign a custom name to each channel transport to help identify the server it is on or what it is used for.
  - TSL Tally Setup
    The server can receive TSL messages from a downstream device to tally the channels on the server.
- Remote Control Support
  Use the information in this section to assist you in setting up an external device to control your server.
- Maintenance
  Refer to the following information for performing maintenance on your server, muting an alarm, restoring factory defaults, or upgrading the software.
- AsRun Log Creator
  The server keeps a log of stills and clips that have been played in their entirety on all channel of the server. This information can then be filtered and output into either a CSV file or a PDF report.
- Troubleshooting

To Configure the Hardware Channels

The number of hardware channels on your server depends on the configuration you purchased.

Launch the Tria Config application.

You may be prompted to allow the program to make changes on the computer, click Yes.
Click the Channels tab.

Note: Your selections may appear different, depending on the number of channels you have.
Select the video processing mode and how you want the channels grouped.
Click Apply.