To Insert a Special Event into a Custom Control

A special function can be inserted into any existing custom control, or used when creating a new custom control.

  1. Start recording or editing your custom control where you want to insert the special event.
  2. Click Insert Event.
  3. Click an Event button for the event you want to insert.
    You can also press and hold the INSERT button and press the source button on the custom control bus for the event you want to insert. The event names are shown on the mnemonics.
    • Hold — insert a hold event
    • Pause — enter the length of the pause event in the Seconds and Frames fields
    • Loop — loop the custom control back to the beginning
    • GPO — click a Pin button to select the GPI output
    • Cut Key — click an ME, Key, and State button to select whether you want the key cut on or off
    • Trans Key — click an ME, Key, and State button to select whether you want the key transitioned on or off
    • Include Key — click an ME, Key, and State button to select whether the key should be transitioned on-air or off-air with the next transition
    • Resume — enter the bank (Bank) and custom control (CC) you want to resume
    • Cancal — enter the bank (Bank) and custom control (CC) you want to cancel
    • Cancel All — insert a cancel all custom controls command
    • State — insert the switcher state
  4. Click Insert to insert the event.
  5. Click Stop Recording.