To Load a Set

Switcher Sets can only be loaded from a USB drive. The USB drive must be present before you try to load the settings.

  1. Insert your USB drive into the USB Port on the frame or control panel. You must wait 5 seconds for the switcher to recognise the USB drive.
  2. Click Navigation Menu > Configuration > System > Load Sets.
  3. Click the Available Set button for the set you want to load the switcher registers from.
  4. Click the Load button to select the registers you want to load from the selected set.
    • All — load all registers from the set.
    • Mems — load only the memory registers from the set.
    • Cust — load only the custom control registers from the set.
    • Inst — load only the installation registers from the set.
  5. Press Ok.