To Set the Memory Attributes

Memory attributes can be set when the memory is stored or when it is recalled. This procedure sets the recall attributes, but the information applies to both.

  1. Click Navigation Menu > Live Assist > Memory > Recall.
  2. In the Inclusions area, select the MiniME™ and MultiScreen that you want to include with the memory recall.

    Only those MiniME™s or MultiScreen that are included with the memory recall are changed when a memory is recalled.

    Tip: Click the attribute button multiple times to have that attribute included with the recall (), not included with the recall (), or use the setting stored in the memory ().
  3. Click General and select the attributes that you want recalled with the memory.
    • Roll Clip — whether GPI outputs attached to sources are triggered when recalled.
  4. Click MiniME X-y and select the attributes that you want recalled with the memory.
    Tip: You can use the same procedure for a MiniME™.
    • Trans Area — how the next transition type and parameters are recalled.
    • Next Trans — how the next transition area is recalled.
    • Run Auto — whether a transition is performed after the memory is recalled.
    • PGM Bus — how the sources selected on the program bus are recalled.
    • PST Bus — how the sources selected on the preset bus are recalled.
    • KeyX Bus — select whether sources selected on the selected key bus are recalled.
    • KeyX Active — whether the selected key is recalled on-air (active) or not.
    • KeyX Type — whether the key type is recalled for the selected key.
    • KeyX Mask — whether mask settings for the selected key are recalled.
  5. Click Auxes and select how the sources selected on the aux bus are recalled..