To Configure the Server for Replay

Configure the server channels for the required ISO mode and assign channels to a Control Surface.

Note: You must connect the Control Surface to the server before you try to configure the server. The server will detect the Control Surface and allow you to assign channels to them.
  1. Launch the Mira Config application.

    You may be prompted to allow the program to make changes on the computer, click Yes.

  2. Click the Channels tab.


  3. Select the ISO mode for the number of cameras and playout channels that you require.
  4. Click Apply.
  5. Click the Control Panel tab.


  6. Click Control Panel Identifier and select the Control Surface that you want to assign to channels.
    Tip: Each Control Surface is identified by its MAC address, which can be found on a label located on the back of the unit.
  7. Click Apply.