To Run the RAM Test

The switcher can be set to perform a RAM test every time it powers on. To enable this feature, set DIP switch 1 (8 on Carbonite eXtreme) on the frame to the on position.

Note: When a RAM test is started, it must be allowed to finish. If the test is interrupted by a power cycle, the test will continue when the switcher powers on again. This may appear as if the switcher is failing to power on correctly, or is stuck in an upgrade.
  1. Press MENU > SYSTEM > NEXT > NEXT > Diag Tests > NEXT > RAM Test.
    The top line of the menu shows the result of the last RAM test.
  2. Press the Reboot knob to run the test.
    The switcher runs the test and then reboots.
  3. The results of the test are shown on the top line of the menu.
  4. Press MENU to end the test.