To Set the LiveEDL Behavior

Important: A control panel is required to perform this procedure. If you do not have access to a physical control panel, the SoftPanel can be used. The position of items on the menus on the SoftPanel may not match those of a physical panel.
  1. Press MENU > System > NEXT > NEXT > NEXT > LivEDL Config.
  2. Use the GPO knob to select the GPI output that is connected to your video server.
    The GPI must be configured as a GPI output before it can be selected.
  3. Use the Triggr knob to select when the GPI output is triggered.
    • Off — GPI is not triggered
    • Start — GPI output is triggered at the beginning of the EDL capture
    • Stop — GPI output is triggered at the end of the EDL capture
    • Both — GPI output is triggered at the beginning and end of the EDL capture
    If Start or Both is selected, you must set the pre-delay for the GPI.
  4. Use the PreDly knob to select the pre-delay interval (in frames) that the switcher waits after the GPI output is triggered before starting to capture EDL data.